The specified client configuration does not contain valid WCF error

When setting up client configuration, you may encounter the error "The specified client configuration does not contain valid wcf"  to resolve this error, follow below steps.

1)Open the .axc where this issue was being seen in the Microsoft Dynamics AX Configuration Utility.

2)Click on the 'Connection' tab

3)Click on the 'Refresh' button and wait for the process to complete.

4)Click on the 'Configure Services' button'

5)You will now see the info message. Click 'Ok'

Note 1 - Clicking 'Configure Services' will give this information. Click 'Ok'

6)You will now see the info message. Click 'Yes'

Note 2 - Clicking 'Ok' in Figure 2 gives this message. Click 'Yes'

7)You will now see the info message. Wait for the process to finish.

Note 3 - Clicking 'Yes' will show this process window.  Wait for it to finish

8)You will now see the info message. Click 'Ok'

Note 4 - Once the above process is complete, this information is presented. Click 'Ok'

9)A new window for Microsoft Service Configuration Editor will appear.  You can close this screen.

Note 5 - This pops up at the end of the process.  Just close out of it.

10)Save this configuration

11)Open the config file and verify there is an XML section of the file.